
How to Remove Oil & Haldi Stains from Kitchen Tiles
By Wipezy Author8 min read
Table of contents
If you want to know how to clean kitchen tiles with oil and haldi on them, start with the oil. Spray a degreaser or use warm water with some dish soap, wait a few minutes, then wipe. Haldi hardly dissolves in water, so if the yellow is still there after that, rub it with a cotton cloth dipped in a little rubbing alcohol.
Go stand next to your gas stove and look at the wall. The tiles closest to the burner have a yellowish film on them, and higher up there are little orange dots from the tadka. The grout between them used to be white. Now it's more beige. Two tiles away, everything looks fine.
If you've tried cleaning that with one soapy cloth, you know half of it doesn't budge. It's not because you didn't rub enough. There are actually two stains there, oil and haldi, and they don't come off the same way. We'll go through how to clean kitchen tiles like these one step at a time, starting with the oil.
Oil and Haldi Don't Come Off the Same Way
Oil first. Plain water just slides over it, even warm water, since oil and water don't mix. It needs dish soap, a degreaser or a foam cleaner, and it needs a few minutes sitting on the tile before you wipe.
Haldi is different. Its colour comes from curcumin, and curcumin barely dissolves in water, though it goes easily into alcohol and other solvents. So you can wipe a haldi mark with a wet cloth ten times and it'll still be yellow, just spread out a bit more.
In our kitchens the two nearly always land together. When the tadka splashes, it's hot oil with haldi, mirchi and masala in it, and the yellow ends up sitting inside the grease. Start with the colour and you're basically rubbing through a layer of oil. Get the oil off first and a lot of the yellow goes with it.
Know Your Tiles Before You Pick a Cleaner
Before you buy or mix anything, check what your kitchen actually has. Different tiles need different handling.
-
Wall tiles that shine are usually glazed ceramic or vitrified, and they’re fine with nearly any kitchen cleaner
-
Matte or anti-skid floor tiles are rough to touch. Oil gets stuck in them, so use a brush
-
Granite, Kota and marble are stone. Lemon and vinegar can take the shine off them
-
The grout lines, if they’re cement, soak up oil and haldi both
One thing for every kitchen: no steel wool, no rough scouring powder on glazed tiles. The scratches are too small to see in the beginning. But the oil and haldi from next week go right into them, and the tiles get a little harder to clean each time.
How to Clean Kitchen Tiles Covered in Oil
Turn the gas off and give the tiles near the burner some time to cool. Spray cleaner on a hot tile and it dries before it can do anything.
-
Dry cloth first, to get rid of dust and crumbs.
-
Then spray your degreaser, or warm water with a few drops of dish soap, on the oily part.
-
Leave it three to five minutes. Most people skip this and wonder why it didn't work.
-
Wipe with a soft sponge, starting at the top so dirty drips don't land on tiles you've finished.
-
Still sticky? Go over it again, with a soft brush on any textured bits.
-
One wipe with a cloth rinsed in plain water, and dry it off.
On a wall, foam is easier to work with than a runny liquid, since it stays put instead of dripping onto the counter. Our kitchen stain cleaner is made for exactly this kind of splatter behind the stove. Spray, give it a minute or two, and wipe it away with a damp cloth.
Grease that's been sitting for months gets hard, almost like old varnish. Please don't go at it with a knife. Do two or three rounds of cleaner with a wait in between, and it'll soften up.
Getting Haldi Off Once the Grease Is Gone
Once the oil's gone, a lot of the haldi marks already look much lighter. For the rest, start with dish soap on a damp sponge.
You might see the yellow go reddish-brown for a moment when soap or baking soda touches it. That's normal. Curcumin changes colour when things are alkaline, and most soaps are. Nothing has happened to the tile. It's the same stain in a different colour, and it mostly turns back.
If there's still a yellow tint after the soap, try alcohol. A bit of rubbing alcohol on a cotton cloth, or hand sanitiser if that's what's in the house, rubbed gently on the spot. Curcumin dissolves so much better in alcohol than in water that this usually lifts whatever the soap left behind. Just keep the gas off and a window open while you do it. Alcohol catches fire easily.
Grout Holds On to Both
Sometimes the tiles look clean and the lines in between are still yellow-brown. Cement grout has tiny pores, so oil and haldi soak into it rather than sitting on the surface.
For these, mix baking soda with a few drops of dish soap, press it into the grout with an old toothbrush and leave it about ten minutes. Then scrub and rinse. Don't keep using vinegar on grout, though. Acid slowly wears cement grout away if you use it too often.
Planning to redo the kitchen? Ask the tile mistri about epoxy grout for the wall behind the stove. It costs more, but it doesn't have those pores, so stains stay on top and wipe off. For the grout you've got now, a sealer once a year helps it stain a lot less.
When Clean Tiles Still Look Dull
Every now and then the stains are gone but the tiles still look cloudy, especially when sunlight comes in from the side. Most of the time that's soap that dried on the tile, not dirt. It leaves a thin film that shows up as streaks on glossy tiles, and that film grabs fresh oil faster too.
Go over the tiles one more time with a cloth wrung out in clean warm water, and change the water once it looks cloudy. Dry them with a microfibre cloth after. And use less soap next time. A few drops in a mug of warm water is plenty for most of the wall. This is a big part of how to clean kitchen tiles so they don't end up streaky.
The Floor Right Below the Stove
Before you worry about the stain, worry about someone slipping on it. For a big oil spill, scatter dry atta or besan on top, leave it for a minute, then sweep it all up. The flour pulls the oil in, and your mop won’t end up spreading it across the floor.
After sweeping, mop with warm water and a little dish soap. Matte and anti-skid tiles are rough, which keeps the grease in, so scrub the oily bit with a hard brush. For the little drips you get near the stove every day, an active foam cleaner saves effort. Spray it, leave it a minute and wipe, then mop once with plain water, or the floor stays slippery.
Stopping the Build-Up Next Time
Almost all of this comes from splashes being left for weeks. Wiping the tiles behind the stove a couple of times a week with a damp cloth and a drop of soap stops the oil from turning into that sticky layer. Haldi spills, wipe them the same day.
Switch the chimney or exhaust on before the tadka goes in, not once the smoke has started. A splatter screen on the kadhai also keeps a surprising amount off the wall.
A Cleaner Wall Behind the Stove
So that's how to clean kitchen tiles when oil and haldi have both had time to settle in. Oil goes first, then the haldi, then the grout. Use soft stuff on glazed tiles, keep vinegar and lemon off stone, and try to wipe the wall behind the stove before the splashes get a chance to set.
Frequently Asked Questions
Q1. Can I use vinegar to clean kitchen tiles?
A. On glazed ceramic tiles, diluted vinegar once in a while is okay. Keep it off granite, marble and Kota stone, and don't make it a habit on cement grout.
Q2. Can I use a bathroom tile cleaner in the kitchen?
A. Better not. A lot of bathroom cleaners are acid-based, meant for hard-water marks and not grease. They don't do much to oil, and they can harm the grout.
Q3. Why did the haldi stain turn red when I cleaned it?
A. Soap and baking soda are alkaline, and curcumin goes reddish in alkaline conditions. It's still the same stain, just a different colour for now. Keep cleaning and it'll come off.
Q4. How often should I clean kitchen tiles?
A. The tiles behind the stove, two or three times a week. The walls, grout and floor around the stove, a proper clean once a month.